|
There are currently no product reviews.
 ;
Excellent printing quality. A complete and very useful manual with all details.
;
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
PULLEY, MOTOR, DAMPER
Remove the back cover. Take off the belt turning the pulley. Unscrew the bolt to pull out the pulley.
(PULLEY)
Unscrew 2 screws from the bracket. Push the motor in the arrow direction for disassembling. When reassembling the motor, make sure that motor
1 3
2
mounting bushings are not taken off from the bracket.
(MOTOR)
Hinge, Damper
Damper
Pull out the hinge, pressing its snap. Do not use the pulled out hinge again. It may be taken off during operation.
(DAMPER)
Clean the drain pump filter
3 1 2
3
2
Open the lower cover cap ( ) by using a finger Turn the drain plug ( to pull out the hose.
)
Unplug the drain plug ( ), then the water flows out, At this time use a vessel to prevent water flowing on the floor. If the water does not flow any more,turn the pump filter ( ) open to the left.
Take out any foreign material from the pump filter ( ). After cleaning, turn the pump filter( ) clockwise and insert the drain plug ( )to the original place. close the lower cover cap.
30
|
